Order Page – MDT Metal Magazines
DETAILS
MDT AICS-pattern metal magazines are manufactured from high strength steel, nitrided, and finished inside and outside with Cerakote Elite for ultimate durability, corrosion resistance, and friction reduction.
Compatibility
6mm BR
- 6mm BR Norma
- 6mm BRA
- 6mm BRX
- 6mm Dasher
- 22 BR
.223 REM
- 223 Rem
- 5.56 NATO
.308WIN / 6.5 CREEDMOOR
- .308WIN
- 6mm Creedmoor
- .243WIN
- 260 Rem
- 6.5 Creedmoor
- 7mm-08 Win
- 308/7.62×51 NATO
- 22 – 250 Rem (will work at a reduced capacity)
Specifications
6mm BR
- 6mm BR Norma
- 6mm BRA
- 6mm BRX
- 6mm Dasher
- 22 BR
.223 REM
10-Round:
- 3.055” Outside Length
- 3.90″ Rear Height (same height as MDT 10-rd .308 metal magazines)
- 2.50” max cartridge overall length (COAL)
- Polymer feedlip inserts extend ~0.5″ past the end of the metal feedlip backer, thus retaining the round longer, helping ensure the tip of the round has entered the chamber before the rear of the round is released.
.308WIN / 6.5 CREEDMOOR
5-Round:
- 3.055” Outside Length
- 2.870” max cartridge overall length (COAL) with binder plate
- 2.960” max cartridge overall length (COAL) without binder plate (see limitations below)
- 2.52” Rear Height
10-Round:
- 3.055” Outside Length
- 2.870” max cartridge overall length (COAL) with binder plate
- 2.960” max cartridge overall length (COAL) without binder plate (see limitations below)
- 3.90” Rear Height
12-Round:
- 3.055” Outside Length
- 2.870” max cartridge overall length (COAL) with binder plate
- 2.960” max cartridge overall length (COAL) without binder plate (see limitations below)
- 4.61” Rear Height
BINDER PLATE DETAILS
- The magazines with front binder plates are compatible with all rifles equipped with AICS-pattern bottom metal or chassis systems. The binder plate holds the cartridges back from the front of the magazines and guides them past the bottom of the feed ramp. The maximum cartridge overall length (COAL) that will fit in this magazine is 2.870”.
- The magazines without front binder plates allow a maximum cartridge overall length of 2.960”. These are compatible with all AICS-pattern bottom metal and chassis systems, but most common actions such as Remington 700 and Savage 10/11 will require modifications to the receiver (i.e. notching out the bottom of the feed ramp) to prevent the bullet tips from catching on the bottom of the feed ramp (see photo below).